Double Insulation For Safer Operation - Metabo HPT CM 5SB Manual De Instrucciones

21. Do not start the cutter while the diamond wheel is
in contact with the material.
22. Keep the motor interior free of water.
23. Prior to use, be sure to check the diamond wheel
in such details as crack, broken part, bent part
and the like.
Don't use a diamond wheel if any of the above defect
is found on the wheel. Also confi rm that no abnormality
exists by actual test running.
24. Proceed with cutting operation when full speed
has been reached.
25. Do NOT apply excessive force.
26. When cutting concrete, tile, or stone, the maximum
cutting depth should be held to within 13/64"
(5 mm).
27. Never lay down the cutter while the diamond wheel
is revolving.
Also, do not stop the cutter with the diamond wheel
forcibly depressed against the material.
28. Exercise care to position the cutter at a safe, stable
spot when cutting.
29. Take good care of the power tool and keep it clean.
30. Secure the workpiece and check that the
workpiece is properly supported. A workpiece
clamped with clamping devices or in a vice is held
more securely than by hand.
31. Defi nitions for symbols used on this tool
V .............volts
Hz ...........hertz
A .............amperes
n .............rated speed
W ............watt
...........Class II Construction
---/min .....revolutions per minute
MAKE THEM AVAILABLE TO OTHER USERS
SAVE THESE INSTRUCTIONS
AND
AND
OWNERS OF THIS TOOL!
DOUBLE INSULATION FOR SAFER
OPERATION
To ensure safer operation of this power tool, metabo HPT
has adopted a double insulation design. "Double insulation"
means that two physically separated insulation systems have
been used to insulate the electrically conductive materials
connected to the power supply from the outer frame handled
by the operator. Therefore, either the symbol " " or the
words "Double insulation" appear on the power tool or on
the nameplate.
Although this system has no external grounding, you must
still follow the normal electrical safety precautions given in
this Instruction Manual, including not using the power tool
in wet environments.
To keep the double insulation system eff ective, follow these
precautions:
○ Only metabo HPT AUTHORIZED SERVICE CENTER
should disassemble or assemble this power tool, and
only genuine metabo HPT replacement parts should
be installed.
○ Clean the exterior of the power tool only with a soft cloth
moistened with soapy water, and dry thoroughly.
Never use solvents, gasoline or thinners on plastic
components; otherwise the plastic may dissolve.
English
7