Publicidad
Idiomas disponibles
Idiomas disponibles
Using the grater
•
In combined mincer-grater models, remove the mincer set before using the grater.
•
Lift the grater lever and place the product to be processed inside the grater mouth.
•
Lower the grater lever and turn the switch on position "I".
•
Gradually press the lever until the product is finished.
•
In order to stop the machine, turn the switch on position "0".
•
At the end of processing lift the lever and introduce more product into the grater mouth; lower the lever
once more and turn the switch on position "I".
•
At the end of the work session turn the switch on position "0".
•
At the end of the work cycle, grate a piece of hard bread or use the appropriate brush to clean the roller.
Using the mincer
•
In combined grater-mincer versions, lower the grater lever.
•
Tighten the filler knob in the versions mod. AB12/TX-LX – AB22/TX - TR12/SX – TR22/SNX.
•
Rotate the knobs in versions mod. AB12/ATX – AB22/AEX – TR12/TSX– TR12/CX – TR22/TEX –
TR22/CX.
•
Tighten the handwheel on the output mouth of the mincer without blocking.
•
Start-up the machine by turning the switch on position "I".
•
Place the product inside the upper mincer mouth and press it down using the pestle supplied.
•
At the end of the work session turn the switch on position "0".
•
At the end of the work cycle remove the mincer set and wash using suitable detergents (not aggressive)
in hot water and dry properly.
Dismantling the mincer set
Mod. AB12/TX-LX –AB22/TX–TR12/SX–TR22/SNX:
•
Remove the hopper from the upper mouth.
•
Rotate the handwheel anti-clockwise.
•
Extract:
-
the mincing plate;
-
the blade;
-
and the volute, in sequence
•
Unscrew the filler knob by turning anti-clockwise
and extract the mincer filler.
•
Perform operations in reverse order to reassemble
the mincer group.
Mod. AB12/ATX - AB22/AEX - TR12/TSX – TR12/CX
– TR22/TEX – TR22/CX:
•
Remove the hopper from the upper mouth.
•
Turn the handwheel anti-clockwise.
•
Extract
-
the mincing plate;
-
the blade;
-
and the volute in sequence
•
Rotate the mincer body-blocking knob and extract
mincer body.
•
Perform operations in reverse order to reassemble
mincer group.
INFORMATION: Prior to each work cycle ensure that the removable parts are properly
fixed to the machine.
OPERATION AND
CLEANING
6
3
Publicidad
