Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRICAL CONNECTION
Before plugging in check that:
•
the mains supply corresponds to the value
shown in the specifications table;
•
the socket and the mains lead correspond
to the power requirements of the applian-
ce;
•
the socket is suited to the plug
,
otherwise have the socket replaced;
•
the socket is properly grounded. The
manufactures cannot be held responsible
for any damages due to failure in following
normal safety procedures.
Replacement of the power cable must be
carried out by qualified personnel.
AS AIR CONDITIONER
With the unit turned off, the function selector
is in the "0' position.To turn the unit on in air con-
ditioning mode, proceed as follows:
1. Rotate the function selector dial clockwise:
•
Place the large star symbol -*in line with the
reference mark to operate the unit in air con-
ditioning mode at maximum fan speed.
•
Place the small star symbol * in line with the
reference mark to operate the unit in air con-
ditioning mode at minimum fan speed.
2. Now set the required temperature by rotating
the room thermostat dial
Note
The temperature is not expressed in degrees. We
therefore recommend rotating the room ther-
mostat dial
to the maximum cool position.
When room temperature has reached the requi-
red level, rotate the thermostat dial SLOWLY
clockwise until the thermostat is actlvated, tur-
ning the unit off. Thls programs the unit to the pre-
cise level of comfort required which will then be
automatically maintained by the thermostat
with considerable energy savings. When regula-
ting the thermostat, the air conditioning function
is temporarily interrupted and the unit continues
to operate in fan/ver' tilation only mode. In this
way, the appliance keeps the air temperature in
the room homogeneous.
Note: cool air is discharged from grill gl only
after a delay of three to five minutes.
THIS UNIT EMPLOYS AN EXCLUSIVE CON-
DENSATION
RECYCLING
SYSTEM
TO
DISPOSE OF EXCESS MOISTURE.
IN NORMAL CONDITIONS, CONDENSA-
TION IS DISPOSED OF AUTOMATICALLY.
WHEN THE HUMIDITY IS PARTICULARLY
HIGH, AN EXCESS OF CONDENSATION
MAY BUIU UP IN THE TANK. WHEN THIS
HAPPENS, THE INDICATOR LIGHT 4 [j#]
.INDICATING THAT THE TANK Ei]SHOULD
BE EMPTIED. IF THIS PROBLEM IS RECUR-
WATER FROM THE TANK
DIRECTIY INTO
INTERNAL DIAMETER OF 12 mm.
PUT BACK CORRECTLY OTHERWISE THE
LIGHT *j WILL REMAIN ON (SEE FIGURE)
1 L -Ln
1 fu--
AIR FILTRATION WITH FAN
Rotate the function selector i El anti-clockwise.
•
Place the large symbol * in line wilh the refe-
rence mark to operate the unit at maximum fan
speed
•
Place the small symbol * in line with the refe-
rence mark to operate the unit at minimum fan
speed.
HOW TO DEHUMIDIFY (mod. F130 eco)
When the appliance is working as an air conditio-
ner, it automatically reduces the excess humidity
in the air present In the room. Some models have
the facility to dehumldify as a separate function. In
this case turn the function selector dial in an
clockwise direction untillhe d
symbol is reached
Note
In the dehumidifying mode, air colder than the
room temperature will exhaust from the air exhaust
ture will be exhausted from the opening 3 on the
back of the appliance
18
Publicidad
