Publicidad
Idiomas disponibles
Idiomas disponibles
b) Charging with solar panel (maximum charging power: 200 W). Solar panel is optional.
Place the solar panel in a location where it can receive as much direct sunlight as possible.
The charging status can be checked on the LCD display (3). Charging will end when the battery is fully
charged.
NOTES:
1. For charging from a wall socket, use only the charger specified by the manufacturer.
2. For solar charging, a solar charger with the following specifications is recommended.
- DC output: 12-30 V Over 200 W
- Charging type: MPPT
- Connector: DC male connector
How to use the EC5 port
a) To assist in starting the car (to supply power to the car battery), but ensure that the remaining
battery capacity is at least 60% before using this function.
b) Observe the correct polarity of the starter cables.
c)
After connecting the starter cables to the battery station, turn on the main power switch and
press the DC button, the display will show DC ON, wait about 10 minutes, press the DC button
again, the display will show DC OFF, remove the starter terminal, try to turn the ignition key to
start the car.
Description of alarm information.
a) Overload
When the output power used is greater than the specified output power that can be used for the model,
the message "OVERLOAD" will be displayed in the alarm area. It is necessary to reduce the power of the
electronic equipment. If the AC output is off at this time, press the AC ON/OFF button again and restart
the unit.
b) High temperature.
When the internal temperature is higher than 35 degrees Celsius or the output power is higher than
nominal power, the cooling fan starts to operate. When the internal temperature is higher than 80 degrees
Celsius, the temperature alarm sounds. The AC and DC outputs are switched off and the alarm area shows
"HI TEMP", which will stop operation immediately. To restart the unit, wait until the temperature drops
below 40 degrees Celsius.
3.4.
Cleaning and maintenance
a)
Always unplug the device before cleaning or putting it away.
b)
Use only non-corrosive cleaners to clean the surface.
c)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
d)
Do not spray the device with a water jet or submerge it in water.
e)
Do not allow water to get inside the device through vents in the housing of the device.
f)
Clean the vents with a brush and compressed air.
g)
The device must be regularly inspected to check its technical efficiency and spot any damage.
h)
Use a soft cloth for cleaning.
i)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
j)
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage the device.
k)
Before storage, the power station must be charged and recharged to full capacity every 6 months.
Otherwise, the battery capacity will not be restored.
CAUTION:
Low temperatures (below zero) can affect the capacity of the power station battery. Never charge the
unit in sub-zero conditions as this will damage the lithium-ion battery and its capacity may not be
restored.
EN
Publicidad
