General Operation; Before Using; Common Operation; Function Setting Operation - Kenwood KDC-BT645U Manual De Instrucciones

General operation

Before Using

Exit of the Demonstration Mode
Turn off the demonstration mode when you use it
for the first time after installation.
1
Press the [VOL] knob to quit the demonstration
mode when the messages "CANCEL DEMO" and
"PRESS", "VOLUME KNOB" are displayed (approx.
15 seconds).
2
Turn the [VOL] knob to select "YES" and press the
[VOL] knob.
⁄
• The demonstration can be set or cancel using
<Demonstration Mode Setting> (page 20).

Common Operation

Power and source select
Turns the power ON by pressing the [SRC]
button.
Pressing [SRC] button each time switches
between sources.
Tuner ("TUNER" or "HD RADIO") ➜ USB or iPod
("USB" or "iPod") ➜ CD ("CD") ➜ Auxiliary input
("AUX") ➜ Standby ("STANDBY")
Keeping pressing the [SRC] button at least 1
second turns the power OFF.
⁄
• When connection of the iPod is recognized, the source
display changes from "USB" to "iPod".
• The source "CD" and "iPod" can be selected when each
source is ready to play.
• When an optional accessory is connected, the source
name for each device appears.
Volume
Turning the [VOL] knob adjusts the sound
volume.

Function Setting Operation

The basic operating procedure for using this
function is described below. The individual function
items are covered in the operating procedures.
1
Select the source
Press the [SRC] button.
Function items vary from source to source. For a list
of the function items. Refer to <Function Item List>
(Page 34).
2
Enter Function Setting mode
KDC-BT645U: Press the [VOL] knob for at least
1 second.
KDC-HD545U: Press the [VOL] knob.
"FUNCTION" is displayed.
3
Select your desired function item
Turn the [VOL] knob and press it when the
desired item is displayed.
Repeat the operation until your desired function
item is selected.
⁄
Press the [ ] button to return to the previous
item.
Example:
AUDIO CONTROL
SUBWOOFER SET
DETAILED SET
LPF SUBWOOFER
DISP SELECT
SETTINGS
In this manual, the above selection is indicated as
Select "AUDIO CONTROL"
"LPF SUBWOOFER".
4
Make a setting
Turn the [VOL] knob to select a setting value,
and then press the [VOL] knob.
5
Exit Function Setting mode
Press the [ ] button for at least 1 second.
[VOL] [VOL]
> >
"DETAILED SET"
5
|
English