Blackstone PRO Serie Manual Del Propietário página 11

Model 2007
S T E P 0 2
Use the four (4) pre-installed M3 bolts and M3 nuts to attach the
two (2) lower door magnets to the cart base.
With the help of another person, place the griddle body on its wheels.
Use the four (4) pre-installed M3 bolts and M3 nuts to attach the two (2)
upper door magnets to the front logo panel.
TROUBLESHOOTING
Visit BLACKSTONEPRODUCTS.COM/SUPPORT for additional
troubleshooting.
Section 01
BAT TERY POWERED IGNITION
SYMPTOMS
01. Burner will not Light with ignition system
02. Pressing the ignitor button does not result in a clicking sound
If ignition does not occur in 5 seconds, turn the burner controls off, wait 5
minutes and repeat the lighting procedure.
If this does not work, to determine the cause, please try to ignite your griddle
with a match. (Please reference the Match Lighting Instructions in the
Cleaning the Burner Assembly section of the Care & Maintenance chapter.)
S T E P 0 3
Install the inner shelf by resting the shelf on the four (4) inner
shelf brackets, and inserting the leg into the cart base hole.
Insert one (1) AA battery (not included) under the ignition button.
If you CAN ignite your griddle with a match
POSSIBLE CAUSES
01. Dead battery or no battery.
02. Battery installed incorrectly.
03. Ignitor wire misaligned.
04. Damage to the ignition system.
If you CAN NOT ignite your griddle with a match
POSSIBLE CAUSES
05. Burner tubes are not receiving fuel.
SOLUTION
Replace with new battery.
Ensure that the battery is installed nega-
tive end first.
Ensure that the ignition needle is posi-
tioned 1/8" to 1/4" away from the burner
tube, positioned above a burner hole.
Contact customer service for replace-
ment parts.
SOLUTION
Please reference the Gas Flow section of
the Troubleshooting Chapter.
Assembly Guide | Owner's Manual
Troubleshooting
Insert one (1) AA battery (not
included) into the battery socket
with the positive terminal facing
out, then screw on the ignitor
button until tight. Be careful to not
over tighten.
3-7mm
blackstoneproducts.com/support
Ensure that the ignition needle is
07