Micro Gate RACETIME 2 Manual De Usuario página 75

RACETIME 2 – Software "Partenze singole e di gruppo"
Holdoff times
A:LCK-key setup
B:LINKGATE channel
A B
F1 F2
HT Start = 2000 ms
HT Stop =
HT Lap =
HT Aux =
F1 F2
SLLLLLLLLLLLLLLS
T123456789ABCDEP
---------------#
←
Modif
F1 F2
LINKGATE channel:
(S0000000)
(1=ON, 0=OFF)
Modify
F1 F2
17.1.7 Modifying 'dead' times Allows you to modify
the disactivation times of inputs after the acquisition of
an event. This can be done separately for the Start, Lap,
Stop and AUX lines (the AUX line is only used in the
PC On-line program, see chap. E in the manual).
C more
F3 F4
17.1.8 Activating the LCK key Choose this option to
modify the lines on which the LCK key is active (see
also par. C3.2.6). With the arrows (F2 and F3), it is
possible to move the cursor from one field to another.
With 'Edit' (F1) the blocking of the line on which the
cursor is positioned can be activated or disactivated –
500 ms
beginning from the Start (on the far left), passing
500 ms
through Laps 1...14, to the finish (on the far right). The
500 ms
presence of the block is indicated by the # symbol.
Note that the lap times refer to the signals transmitted
via radio using the LINKGATE system. The activation
F3 F4
of the block on LAP 14 (E) also block LAP signals
coming from the keyboard or the inputs.
→ menu
F3 F4
17.1.9 LINKGATE channel Allows you to modify the
LINKGATE system work channel so you can move to
another channel if necessary. On the display, the setting
indication for the 'dip switch' located on the
LINKGATE Encoder will appear. The first selector
does not affect channel selection (its function is to select
0
signal length and is therefore shown with the letter 'S').
Next, the status of the other switches is shown
(1=switch up, 0=switch down). To modify the setting
press 'Edit' (F1). Remember once again that it is
menu
absolutely essential that Racetime2 and the LINKGA
F3 F4
75