Publicidad
Idiomas disponibles
Idiomas disponibles
3. Grille installation
10. Hook the safety strings of the side covers L/R to the grille and install the side covers.
(Fig. 8)
• Make sure that the catches of the side covers L/R are engaged securely. (Fig. 8)
• Open the display cover and check that the positioning marks are aligned correctly.
(Fig. 9)
• Make sure that there are no gaps between the emergency operation switch (E.O.SW)
and the side cover. (Fig. 9)
• Make sure that the safety strings do not hang out of the side covers L/R.
11. Fix the side covers L/R with the side cover fixing screws removed in step 2. (Fig. 9)
Front
-
- S i d e cover
~
Fig. 9
12.Attach the air cleaning filters (option) to the hooks for them on the
intake grille. (Fig. 10)
13. Attach the safety strings of the intake grille to the grille and insert the
shafts into the holes of the intake grille.
14.Close the intake grille. (Fig. 11)
fixing screw
• Press the intake grille firmly against the grille until a "click" is heard from
the each tab on the both sides.
\
'
Fig. 11
4. Checks after installation
Side cover
Display cover
Tab for opening and closing
Attach to the
hook on the grille.
Hook for engaging catch
/
/
/
/
Hook for
/
engaging catch
Fig. 8
Fig.10
• Make sure that there are no gaps between the indoor unit and the grille (1 ), or between the grille (1) and the ceiling surface. Otherwise, air may escape from
the gap and it may cause water to drip from indoor unit.
• Make sure that the air filters are installed in place.
En-3
Publicidad
