Greencut MP500C Manual De Instrucciones página 49

ASSEMBLY
ASSEMBLY AND DISASSEMBLY OF THE DRILL BIT
1. Choose the right drill bit for the type of work you are going to do. For best results use sharp drills.
2. Clean the shaft part of the drill bit.
3. To insert the drill, rotate and center the drill chuck until it locks. Check the locking by pulling the drill bit.
4. To remove the drill bit, pull the handle completely in the direction of the arrow and remove the drill bit in
the opposite direction.
DUST CUP
Use the dust cap by attaching it to the drill bit as shown in the figure. When using a
large diameter drill, enlarge the center hole of the powder cup with the rotary hammer.
DEPTH GAUGE
1. Loosen the wing screw and insert the meter into the side handle mounting bracket.
2. Adjust the position of the meter according to the depth of the hole and tighten the wing nut firmly.
Thumbscrew
Meter
Mounting hole
Side handle
49
Dust cup
EN