Publicidad
Idiomas disponibles
Idiomas disponibles
52
TROUBLESHOOTING
The table includes some of the most common problems, their causes and remedies.
PROBLEM
Light smoke or odour
is produced during
start-up
• Power cord and plug are damaged.
Device does not start
• The fuses are damaged.
The engine runs and
there is no rotational
• The selector is not in the correct
or percussive
movement.
The drill bit does
not penetrate, or
• The material is too hard and the
barely penetrate, the
material to be drilled
The appliance heats
• The tasks to be performed are not
up
NOTE: If you are unable to resolve the problem, please contact the Official Technical Service.
TRANSPORTATION AND STORAGE
•
Stop the tool, allow the tool to cool before storing or transporting.
•
Clean any foreign material from the product. Store in a cool, dry, well-ventilated place out of the reach of
children. Keep product away from corrosive agents such as garden chemicals and thawing salts. Do not store
outdoors.
RECICLYING AND DISPOSING
Worn products are potentially recyclable and should not be disposed of in the usual waste. Help us to protect the
environment and preserve natural resources.
Dispose of the device in an environmentally friendly manner. Do not dispose of it with household waste. Its plastic and
metal components can be separated and recycled. Take this appliance to an approved recycling centre (green point).
Gasoline, used oils, oil/gasoline blends and objects stained with gasoline (e.g., rags) should not be disposed of in
regular trash, sewage, dirt, rivers, lakes or the sea. Oil-stained items should be disposed of in accordance with local
regulations: take them to a recycling center.
The materials used in the packaging of the machine are recyclable: please dispose of them in the appropriate container.
POSSIBLE CAUSE
position.
selected speed is incorrect.
suitable for the tool.
SOLUTION
• After a short time in operation, these signs
disappear.
• Check the mains connection.
• Check the condition of the mains fuses at
the installation site.
• Check whether the function selector is in
position
, or
.
• Check if the correct rotation speed has been
selected
• Check if the correct drill set has been
selected.
• Keep the ventilation slots free to avoid
overheating of the engine.
• Select a lower rotational speed
• Wait 10 minutes before restarting.
Publicidad
