Publicidad
Idiomas disponibles
Idiomas disponibles
SWORD AND CHAIN
Install the sword and chain as follows:
•
Disassemble the tensioner lock and remove the sprocket cover.
•
Install the bar and slide it slowly towards the chain.
•
Position the chain as shown in the drawing. (Make sure the saw teeth are counterclockwise.
•
Install the sprocket cover on the pin, and turn the sprocket wheel. Make sure the tension block passes through
the hole in the bar.
•
Tighten the tension wheel and hold the guide plate.
•
Lift the bar and tighten the nuts.
•
Turn the chain around the bar. If you feel you are too tense, please loosen the regulator.
Chain
Sword
Central hole
Sprocket
3-4 mm
45
EN
Tensor
Publicidad
