Publicidad
Idiomas disponibles
Idiomas disponibles
GREASING THE PINION
The pinion is used to activate the hammer. The pinion operates at high speed and requires lubrication.
To grease the pinion:
1.
Place the machine in a horizontal position with the fuel filler cap facing up on a flat and level surface.
2.
Remove the pinion access cover (A) (rotate left).
3.
Liberally coat the pinion and drive components with automotive bearing grease.
4.
Re-install the pinion access cover (rotate right) and tighten firmly by hand.
A
TRANSPORTATION AND STORAGE
ATTENTION: Always make sure the machine is cool enough to touch before transporting or storing it.
•
Oil / fuel / gasoline are extremely flammable, keep them away from flames or other sources of
ignition.
•
Always transport the machine with the engine ON/OFF switch in the "OFF" position.
•
Drain the fuel tank before transportation or storage.
PREPARING FOR TRANSPORT AND STORAGE
•
Drain the fuel system by allowing the engine to run until it stops.
•
Ensure the engine ON/OFF switch is in the "OFF" position.
•
Avoid exposing the equipment to direct sunlight, particularly during transportation.
•
Ensure the equipment is secure and upright during transport.
•
Store the unit in a dry, well-ventilated area and out of the reach of children.
LONG TERM STORAGE
Follow the normal procedures for storage, then:
•
Drain the fuel system. It is advised to have the fuel tank as empty as possible before draining.
-
a) Unscrew (rotate left) the carburettor drain plug. Use a suitable container to catch the draining fuel,
and allow the fuel to drain. Store the drained fuel in a properly sealed container.
-
b) Re-install (rotate right) the carburettor drain plug and tighten.
•
Remove the spark plug and put 30ml of clean engine oil into the cylinder. Pull the starter rope slowly to distribute
the oil. Re-install the spark plug.
•
Cover the equipment to protect it from dirt and dust.
67
EN
Publicidad
