Publicidad
Idiomas disponibles
Idiomas disponibles
54
BOX CONTENTS
This machine includes the following items which you will find inside the box:
-
1x Welder
-
1x Welding mask
-
1x Brush with ice pick
-
1x Ground cable
-
1x Torch
-
1x Instruction manual
•
Carefully remove the product and accessories from the box. Make sure all the items listed in the above list are
present.
•
Inspect the product carefully to make sure it has not suffered any breakage or damage during transport.
•
Do not discard packaging materials until you have thoroughly inspected the product and used it satisfactorily.
ATTENTION: If any parts are missing or damaged, contact the Authorised Service Centre. Do not
use this product without having replaced the missing or damaged parts. Using this product with
damaged or missing parts can cause serious injury to the operator.
USE OF THE PRODUCT
PANEL OPENING
ATTENTION: Make sure the welder is not plugged in.
To open the panel, pull the safety bar upwards and, while holding it down, pull the cover.
CONTROL PANEL
1. THERMAL OVERLOAD INDICATOR
If the recommended duty cycle is exceeded and the current is too high, the yellow overload indicator light will come
on and the welder will turn off automatically. When the welder has cooled (approximately 5 to 10 minutes), the power
will return to the unit and you can restart welding.
2. ON / OFF SWITCH
When the welding machine is activated, a green light will come on. When you are no longer using the welder, you
must turn it off and disconnect it from the power supply
3. FUNCTION SELECTOR (MAXIMUM AND MINIMUM, 1 AND 2)
When used simultaneously, these switches will allow you to reach two power levels:
- MIN-1
35A
- MAX-1
48A
4. CURRENT INTENSITY CONTROL
As a general rule, a higher current requires a higher speed.
MIN-2
70A
MAX-2
90A
Publicidad
