Würth Durofix RL6040 Manual Información Del Producto página 7

TO INSTALL THE BATTERY PACK: Open the battery shield (5). Align the rails, on
the Uplight with the four tabs on the battery pack, and push battery pack into the
Uplight until it locks in place.
TO REMOVE THE BATTERY PACK: Depress the battery release button, and pull
battery pack out of Uplight.
NOTE:
If the Uplight is run by battery pack, it could run another 2 Uplight at the same time.
INSTALLING OR REMOVING BATTERY PACK
Plug AC power cord (7) into the AC outlet.
NOTE:
When an AC cord is plugged, the Uplight will automatically run on AC power. If the Uplight is
run by AC, it could run another 9 Uplight.
LIGHT ON / OFF AND DIMMING
1. Inert battery pack or plug into AC power.
2. Release Locking nut to turn counting-clockwise.
3. Hold the top hanger (1) and fully pull out the LED uplight (2) until firmly seated.
4. Use dimmer (8) to adjust brightness (10~100%).
5. Push back the LED light to turn the light off.
1English1
5
OPERATION
English -6