Publicidad
Idiomas disponibles
Idiomas disponibles
EN
water flowing.
Error
E0
faults between main
Codes
PCB and display PCB.
temperature sensor
E1
failure.
sensor failure.
E2
Ft
high level alarm.
period of time (more than a few weeks) it is best to clean the unit
and dry it out completely. Please store the unit according to the
following steps:
storage with the unit.
2. Drain the remaining water from the unit.
■ Noise comes from
flowing refrigerant. This
is normal.
■ Check the wire
harness of the display
PCB for damage.
■ Check connection or
replace it. To clean or
replace the temperature
sensor.
■ Check connection or
replace it. To clean or
replace the temperature
sensor.
■ Empty the drain pan
by removing the rubber
plug.
26
3. Clean the filter and let the filter dry completely in a shaded area.
4. Re-install the filter in place.
5. The unit must be kept in upright position when in storage.
6. Preserve the machine in ventilated, dry, non-corrosive gas and
safe place indoor.
ATTENTION:
The evaporator inside the machine has to be dried out before the unit
is packed to avoid component damage and molds. Unplug the unit
and place it in a dry open area for days to dry it out. Another way to
mode, and maintain this state until the drainage pipe becomes dry, so
as to keep the inside of the body in a dry state and prevent it from
mildewing.
8.2 DISPOSAL
Releasing refrigerant into atmosphere is
strictly forbidden!
Do not dispose of electrical appliances as unsorted
municipal waste, use separate collection facilities.
Contact your local government for information
regarding the collection systems available. If
electrical appliances are disposed of in landfills or
dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging
your health and well-being.
27
Publicidad
