Publicidad
Idiomas disponibles
Idiomas disponibles
EN
– Marking to the equipment continues to be visible and legible.
Markings and signs that are illegible shall be corrected;
– refrigeration pipe or components are installed in a position where
they are unlikely to be exposed to any substance which may
corrode refrigerant containing components, unless the components
are constructed of materials which are inherently resistant to being
corroded or are suitably protected against being so corroded.
2.2.9 Checks to electrical devices
Repair and maintenance to electrical components shall include initial
safety checks and component inspection procedures. If a fault exists
that could compromise safety, then no electrical supply shall be
connected to the circuit until it is satisfactorily dealt with. If the fault
cannot be corrected immediately but it is necessary to continue
operation, an adequate temporary solution shall be used. This shall
be reported to the owner of the equipment so all parties are advised.
Initial safety checks shall include:
– those capacitors are discharged: this shall be done in a safe
manner to avoid possibility of sparking;
– that there no live electrical components and wiring are exposed
while charging, recovering or purging the system;
– that there is continuity of earth bonding.
WARNING!
Install the unit in rooms which exceed 9m².
Do not install the unit in a place where
inflammable gas may leak.
10
3. PRODUCT OVERVIEW
3.1 PRODUCT DIAGRAM
1
4
1
Control panel
2
Front display
3
Air outlet with adjustable louver
4
Handle
5
Air inlet with air filter
6
Caster
7
Drainage Hole
8
Air Exhaust
Note: The appearance is only for reference. Please see the real
product for detailed information.
2
3
5
8
6
7
11
Publicidad
