Genie Hand TIME DELAY SAFE Guia De Inicio Rapido página 2

General Information
Any button-activity is confirmed by a signal tone sounds each time a button is pressed. The
maximum distance between 2 activities may not be more than 20 seconds otherwise the
former entering is deleted.
Opening the safe for the first time:
For opening the safe for the first time proceed as follows:
Remove the central plate on the front panel.
1.
Insert the key into the keyhole and turn it into a counterclockwise direction, turn the
2.
knob clockwise at the same time.
Insert 4 batteries 1,5 Volt AA.
3.
Program of the electronical lock
Before you use your safe for the first time you must enter your personal code. Before you
carry out the simply programming please think about your code firstly. Use no personal data
which can be thought by any persons. Keep your code and the keys in safe place where only
you can find it. Do not leave the keys in the safe.
open the safe.
1.
press the black button (inside of the battery slot).
2.
there are two signal-tones and the yellow LED switches on. Now you have 20 seconds
3.
to start programming.
enter the combination you desired (at least 3 numbers, at most 8 numbers) and
4.
confirm your entry by pressing the button "#".
after confirmation of the combination by the button "#" there are two signal-tones
5.
and the yellow LED goes off and shows, that the programming was successful.
Opening the electronical lock
enter your own code and confirm your entry by pressing the button "#".
1.
the green LED flashes and now you have 5 seconds to open the safe.
2.
turn the handle to the right side to open the safe.
3.
Locking device time by entering the wrong code
If you enter the wrong code, there are 3 signal-tones and the yellow LED flashes. Now you
have two more attempts to enter the correct code. If you enter the code 3 times incorrectly
the lock blocks for 20 seconds. During the locking-device-time the lock does not react to any
entry.
Changing the batteries
Open the battery opening on the back of the door.
1.
2. Put in 4 batteries 1,5 Volt AA.
English
Operating instructions