Volkswagen RMT200 Instrucciones De Manejo página 109

BDA 051 228 A BA Radio RMT 200.book Seite 109 Freitag, 20. Juli 2012 12:21 12
Radio operation
Operating the radio
Change the frequency range
The frequency ranges very high frequency (FM) and medium wave (MW/AM
radio. By repeatedly pressing the
be selected.
Automatic station scanning
Press the or keys to start an automatic station scan to the next or the previous station on the
same frequency range. Only stations that can be received are played back.
Automatic station scan with saving radio stations (AutoStore)
In order to start the automatic station scan with saving radio stations, keep the
for a long time. An automatic station scan is started where the 6 stations with the strongest signal are
saved in the current memory level.
Setting the station manually
Setting the station manually can be started by pressing the
shown in the display, you can use the keys to set the frequency manually.
Automatic scanning
SCAN
By pressing the button
search, "SCN" is shown in the display and all stations that have a reception are each played for a few
seconds seconds. For selecting the current station being played and to stop the station scan, the
SCAN
knob must be pressed again.
If the volume is adjusted using the rotary knob
Saving radio stations
There are 2 memory levels (FM1/FM2 and MW1/MW2
available for each frequency range.
A radio station is saved as follows:
Select the desired frequency range (FM or MW/AM
MODE
pressing the button
Set the station to be saved using the automatic or manual station scan.
Keep the desired function button
function button will be lost.
The radio station is saved and the memory level and function button are assigned.
Calling-up a saved radio station
In order to call up a stored station, select the desired frequency range (FM or MW/AM
level (1 or 2) by repeatedly pressing the button
The saved station is selected by briefly pressing one of the function keys
4)
Depending on the AREA selected (
MW or AM.
109
MODE
button, the desired frequency range of the radio operation can
the station scan is started in the current frequency range. During the
1
when scanning for the station, the station scan stops.
4)
or AM1/AM2
4)
) and the memory level (1 or 2) by repeatedly
.
11 pressed until a signal sounds. Any stations previously saved on this
MODE
.
Page 111), the frequency range medium wave can be shown in the display as
4)
) can be received by the
SCAN
button pressed
or for a long time. If "MANUAL" is
4)
), each with 6 storage spaces
4)
) and the memory
11
.