Troubleshooting - Kenwood KDC-X301 Manual De Instrucciones

TROUBLESHOOTING

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
The unit does not work at all.
(For )
"SET ERROR"/"DEL ERROR"
• Radio reception is poor.
• Static noise while listening
to the radio.
Disc cannot be ejected.
Noise is generated.
Tracks do not play back as you
intended them to play.
"READING" keeps flashing.
Elapsed playing time is not
correct.
26
ENGLISH
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the
terminals of the speaker wires are insulated
properly. Turn the power on again.
Send the unit to the nearest service center.
Clean the connectors. ( 29)
Reset the unit. ( 3)
Setting/deleting the remote control ID is
unsuccessful. Turn the power off, then turn on
the power and perform the operation again.
( 5)
Connect the antenna firmly.
Press and hold M to forcibly eject the disc. Be
careful not to drop the disc when it is ejected. If this
does not solve the problem, reset the unit. ( 3)
Skip to another track or change the disc.
Playback order is determined when files are
recorded.
Do not use too many hierarchical levels or folders.
This is caused by how the tracks are recorded.
Symptom Remedy
"LOADING" appears when This unit is still preparing the iPod/iPhone music list. It may
you enter search mode by take some time to load, try again later.
pressing .
Correct characters are not • This unit can only display uppercase letters, numbers, and
displayed (e.g. album a limited number of symbols.
name). • Depending on the display language you have selected
( 5), some characters may not be displayed correctly.
"NA FILE" Make sure the disc contains supported audio files. ( 29)
"NO DISC" Insert a playable disc into the loading slot.
"TOC ERROR" Make sure the disc is clean and inserted properly.
"PLEASE EJECT" Reset the unit. If this does not solve the problem, consult
your nearest service center.
"READ ERROR" Copy the files and folders onto the USB device again. If this
does not solve the problem, reset the USB device or use
another USB device.
"NO DEVICE" Connect a USB device, and change the source to USB again.
"COPY PRO" A copy-protected file is played.
• Check whether the connected device is compatible with this
"UNSUPPORTED DEVICE"
appears. unit and ensure the file systems are in supported formats.
( 29)
• Reattach the device.
"UNRESPONSIVE DEVICE" Make sure the device is not malfunction and reattach the
appears. device.
"USB HUB IS NOT This unit cannot support a USB device connected via a USB
SUPPORTED" appears. hub.
"NO MUSIC" Connect a USB device that contains playable audio files.
• Reconnect the iPod.
"iPod ERROR"
• Reset the iPod.