Troubleshooting - Kenwood KDC-BT752HD Manual De Instrucciones

Installing the Microphone Unit (KDC-X796 only)
Check the installation position of the
1
microphone H.
Remove oil and other dirt from the
2
installation surface.
Install the microphone.
3
Wire the microphone cable up to the
4
hands-free box with it secured at several
positions using tape or the like.
Install the microphone as far away as
■ ■
possible from the cell-phone.

Troubleshooting

Symptom
Sound cannot be heard.
"PROTECT" appears and no operations can
be done.
The unit does not work at all.
Radio reception is poor. / Static noise while
listening to the radio.
"MEMORY FULL" appears.
"NO TAG FNC" appears.
"TAG ERROR" appears.
"IN" flashes.
CD-R/CD-RW cannot be played back and
tracks cannot be skipped.
Disc sound is sometimes interrupted.
"NA FILE" appears.
"NO DISC" appears.
32
English
Peel off the release
coated paper of
double-face adhesive
tape to secure the
microphone on the
place shown above.
Adjust the volume to the optimum level. / Check the cords and connections.
Check to be sure the terminals of the speaker leads are covered with insulating tape
properly, then reset the unit. If "PROTECT" does not disappear, consult your nearest
service center.
Reset the unit.
Connect the antenna firmly. / Pull the antenna out all the way.
The tag memory of HD Radio receiver is full.
The connected iPod does not support iTunes tagging function.
The unit is unable to complete transferring the tagged information to the iPod.
The CD player is not operating properly. Reinsert the disc properly. If the condition did
not improve, turn off the unit and consult your nearest service center.
Insert a finalized CD-R/CD-RW (finalize with the component which you used for
recording).
Stop playback while driving on rough roads. / Change the disc. / Check the cords and
connections.
The unit is playing an unsupported audio file.
Insert a playable disc into the loading slot.
H
Fix a cable with a commercial
item of tape.
Turn the microphone
toward the driver.
Remedy/Cause