GE PVM1790 Instrucciones De Instalación página 10

Installation Instructions
_ ALIGNING THE WALL PLATE
Hole
Draw a Vertical
Line on Wall
_--- from Center of
Top Cabinet
Hole C
ACAUTION'.
Wear gloves toavoidcutting
fingers o n sharpedges.
I
I
olo
4 T
I
Area E J
I
[] Draw a vertical line on the wall at the center of the 30"
wide space.
[_ Use the mounting plate as the template for the rear wall.
Placethe mounting plate on the wall, making sure that
thetabsaretouching thebottomofthecabinet or
thelevel l ine d rawn inStepC forcabinets w ithfront
overhang. Lineup thenotchand center line o n
themountingplate tothecenter line o n thewall.
[_ While holding the mounting plate with one hand, draw
circles on the wall at holes A, B,C and D (see illustration
above/actual plate marked with arrows). Four holes
must be used for mounting.
NOTE: Holes C and D are inside area E.If neither C nor D
is in a stud, find a stud somewhere in area E and draw a
fifth circle to line up with the stud. It is important to use
at least one wood screw mounted firmly in a stud
to support the weight of the oven.
Set the mounting plate aside.
WAR NIN G: Risk ofelectric shock. Can
c ause
injury or death. Take care to not drill into electrical wiring
inside walls or cabinets.
[_ Drill holes on the circles. If there is a stud, drill a sad'hole
for wood screws. For holes that don't line up with a stud,
drill a %" hole for toggle bolts.
NOTE:DO NOT MOUNT THE PLATEAT THISTIME.
10