GE PVM1790 Instrucciones De Instalación página 9

Installation Instructions
[_ DETERMINING WALL PLATE LOCATION UNDER YOUR CABINET
Plate position - beneath flat bottom
cabinet
Plate position - beneath framed recessed
cabinet bottom
ol
Mounting PlateTobs
Touchingthe CGbinet
Bottom
"%
\
At leost 30", up to 36"
Mounting Plate Tabs
Touching the Bock
Frome
Plate position - beneath recessed bottom
cabinet with front overhang
Mounting Plote
with Tabs Below
Cabinet Bottom
the SameDistonce
os the Front
OverhGngDepth
:
..
Your cabinets may have decorative trim that interferes
with the oven installation. Remove the decorative trim
to install the oven properly and to make it level.
THE OVEN MUST BE LEVEL.
Use a level to make sure the cabinet bottom is level.
If the cabinets have a front overhang only, with no back
or side frame, install the mounting plate down the same
distance as the front overhang depth. This will keep
the oven level.
[_ Measure the inside depth of the front overhang.
[_ Draw a horizontal line on the back wall an equal
distance below the cabinet bottom as the inside depth
of the front overhang.
[_ For this type of installation with front overhang only,
align the mounting tabs with this horizontal line, not
touching the cabinet bottom as described in Step D.
30" to Cooktop
I
9