GE PVM1790 Instrucciones De Instalación página 20

Installation Instructions
C3] ADAPTING BLOWER Carefully pull out the blower unit. The wires
il extend far enough to allow you to adjust
FOR RECIRCULATION the blower unit. O N O SS
NOTE: The exhaust adaptor with damper is not
needed for recirculating models. You may want
to save them for possible future use.
Remove and save screws that hold blower plate
to the oven.
¥ §<— Blower Plate Screws
te
Ne Roll the blower unit 90° so that fan blade openings
are facing toward the front of the oven.
Slide the blower plate from under its retaining
flange and lift it off. Remove and save screw that
holds the blower motor to oven.
Retaining
Blower Plate
Blower Motor
Screw
AFTER: Fan Blade
Openings Facing
Forward
NOTE: Make sure wires remain routed in the grooves
of the motor frame.
20