Publicidad
Idiomas disponibles
Idiomas disponibles
Select TEL (Telephone line) in the main menu, select Polarity test (Polarity test), and press the OK button (8).
2.
Possible outcome is shown below:
Port Flash function
This function is used to locate an exact port on a network switch or on a router to which the tested cable is connected.
1.
Plug the loose end of the network cable or the RJ45 patch cord (included) to the Flash/PoE port (11) of the transmitter; the other cable
end is connected to a PoE source equipment (such as a network switch, router, etc.).
2.
Select Flash (Port Flash function) and press the OK button (8).
3.
The circle on the display and LEDs under the Flash/PoE port (11) will flash with the same frequency as the LED of the target port, and
different from the other LEDs.
PoE test
This function is used to identify the pins that provide PoE (power over Ethernet) and to measure the PoE voltage.
1.
Plug one end of the PoE cable or the RJ45 patch cord (included) into the Flash/PoE port (11) on the transmitter and the other end into a
port of the PoE source equipment (such as a network switch, router, etc.).
2.
Select PoE (PoE test) in the main menu and press the OK button (8).
Possible outcome is shown below:
1 ......0v
4 ......
2 ......0v
5 ......
3 ......47.0V
7 ......
6 ......47.0V
8 ......
Visual fault locator (VFL)
The visual fault locator function is used to test fiber cables.
1.
Plug one end of a fiber cable to the VFL port (2) on the transmitter and leave the other end of the cable disconnected.
2.
Select VFL (Visual fault locator) in the main menu and press the OK button (8).
In case of no breakage in the cable, the red LED on the end of the cable will light on. If the fiber cable is damaged, the damaged part of the
cable will glow red.
History record
You can save three groups of test results records: a cable type (CAT5, CAT6, and BNC), a cable length, and a wire mapping scheme.
Specifications
Testing cable types
Cable length measurement range
Max. distance of cable tracing
Wire mapping
Telephone line status test
Polarity test
PoE test
Port flash function
Visual fault locator (VFL)
Max. length of a tested fiber cable
Operating frequency
Low battery indicator
Backlight
Auto-off
History records
Operating temperature range
Power source
The manufacturer reserves the right to make changes to the product range and specifications without prior notice.
Red clamp: 34.8V,
black clamp: 0.0V
STP/UTP (CAT5, CAT6) network cable, coaxial cable,
telephone cable, fiber cable
10–2000m
2000m
+
+
+
+
+
+
10,000m
130kHz
3.5±0.2V
15s, 30s, 1min, off
15min, 30min, 1h, off
6 slots
–10... +60°C / 14...140°F
transmitter: 3.7V, 1400mA.h rechargeable lithium battery
receiver: 3.7V, 1400mA.h rechargeable lithium battery
5V 1A DC adapter
7
Publicidad
