Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING
To avoid accident, cut off the power supply before operation according to
the following instruction.
1.The machine had been disinfected before departed from factory.
Cleaning the dispenser prior to installing a full bottle of water for the first time.
2.Cleaning and draining instruction:
a) Before cleaning, make sure the power switch in the O (off) position and unplug
the water dispenser.
b) Vertically insert the bottle into the supporter on the top of the machine.
c) Turn on all the taps in turn for 3 minutes after the water outflow, which completes
the internal pipeline flushing.
d) Removed the water bottle from the dispenser.
e) Place a large bucket beneath the drain outlet. Remove the drain cover and allow
water to drain.
f) After cleaning, replace the drain cover and you can use the machine.
Attention: The dispenser heats water to a temperature of approximately 85°C. It
can cause severe burns. Please operation it carefully.
3. Sanitizing
The machine should be disinfected with the disinfectant separately bought from
drugstore or marketplace according to the instruction manual of the disinfectant
and then clean it with water (see cleaning and draining instruction). Generally this
should be done every three months.
4. To remove mineral deposits:
Mix 4 liters water with 200g citric acid crystals, inject into the machine and make
sure the water can flow out of the hot water tap. Switch on the power and heat it
about 10 minutes, 30 minutes later, drain off the liquor and clean it with water for
two or three times. Generally this should be done every six months.
Never disassemble this machine by yourself to avoid danger from damaged
machine.
English-8
Publicidad
