Tennant V3 Manual De Funcionamiento Y Lista De Componentes página 5

English
Preparing Machine for Operation:
1. Release the latches (Fig. 1) and remove the lid to ensure that the dust bag and cloth filter are installed (Fig. 2 & 3).
To install the dust bag, simply lift out the secondary cloth filter (Fig. 2) and slide the dust bag opening over the air entrance
connector (Fig.3). Make sure the arrow on the front of the bag is pointing downwards (Fig.3).
NOTE: The seal around
the dust
bag
opening should
cover
the air entrance connector inside the housing.
Replace the cloth filter and lid and lock the lid down with the two latches (Fig. 5)
2. Insert the vacuum hose into the base of the machine by turning the hose clockwise until it is secure (Fig. 6).
3.
Attach the telescopic wand onto the vacuum hose (Fig. 1) and attach the desired cleaning tool (Fig. 2)
4. To extend the telescopic wand push the button downwards while extending the lower part of the wand (Fig. 3).
NOTE:
If there is too much suction when using a cleaning tool release some suction by pushing the button up on the hose
handle (Fig. 4).
Tennant V3 (12-2014) 5