Greencut ATS Serie Manual De Instrucciones página 40

40
TROUBLESHOOTING
The table includes some of the most common problems, their causes and remedies.
The ATS does not start the generator set.
The generator has been started successfully for the third
time switching load power from main power supply to
generator supply failure circuit.
When the ATE controller switches from generator power
supply to main power supply, and if the engine does not
stop in a time.
ATTENTION: If the power supply is not steady when the main power supply is on, the ATS does not
work immediately, it will only start running when the main power supply is steady.
NOTE: In the event of not being able to resolve the problem, contact the Official Technical Service.
RECICLYING AND DISPOSING
Worn products are potentially recyclable and should not be disposed of in the usual waste. Help us to protect the
environment and preserve natural resources. Dispose of the device in an environmentally friendly manner. Do not
dispose of it with household waste. Its plastic and metal components can be separated and recycled. Take this
appliance to an approved recycling centre (green point).
The materials used in the packaging of the machine are recyclable: please dispose of them in the appropriate container.
GUARANTEE
GREENCUT guarantees all GREENCUT products for a period of 24 months (valid for Europe). The warranty is subject
to the date of purchase taking into account the intended use of the product.
As a condition subject to warranty, the original receipt must be presented indicating the date of purchase and its
description as well as the defective tool.
The warranty does not cover normal wear and tear, especially on blades, blade fasteners, turbines, light sources,
fan and transmission belts, impellers, air filters, spark plugs and damage caused by improper use, especially non-
compliance with operating and maintenance instructions.
In the event that repairs or modifications have been made by the consumer or other than with original GREENCUT
spare parts, the warranty will be voided.
In the event of a justified warranty claim, we are entitled, at our discretion, to repair or replace the defective tool free
of charge. Other claims beyond this warranty are not valid.
PROBLEM
You should check if there is enough battery output
voltage or not. If there is not enough battery output
voltage, please charge the battery according to the
generator user manual.
If there are no other generator problems, and there is
an adequate amount of fuel, you can reset the "Control
Unit" button, and start the engine again.
Please check if the switch is off (When the ATS controller
is running this switch should be off).
SOLUTION