Greencut MMA-200 Manual De Instrucciones página 39

OPERATION
-
Set the ON/OFF switch to the ON position, so that the power indicator and the fan come on.
-
Adjust the current as per your needs using the current control.
-
Under normal circumstances, the electrode and the corresponding welded values are:
Electrode diameter (mm)
Current (A)
OPERATION CYCLE
Make sure that the machine works within the indicated parameters on the technical data label:
• X: Operation cycle (% of minutes) in which the welding machine can work continuously to a certain current
without overheating. For example: 60% is equivalent to 6 minutes working and 4 minutes without working.
• If these work times are exceeded, the overload warning light will come on and you must stop working.
ATTENTION: If the overload warning light comes on, stop working and wait until the engine cools
down until the light comes off before using the machine again. Failure to follow these instructions
will void the guarantee.
MAINTENANCE, STORAGE AND TRANSPORTATION
• Remove dust from the machine and always clean the fan outlet before use. It is recommended to clean the welder
once a month if it is not used.
• Check the connections.
• Keep the machine dry.
• Store the welder in its box (al text original "utilizarla" hauria de ser "utilizarlo") if you are not going to use it for
a long period of time.
• To carry out the transport of the machine, make sure it is completely switched off and safely fastened.
• Store this product out of the reach of children.
Ø1.6 Ø2.5
35-50 60-130
39
EN
Ø3.2
90-180