Klarstein LOIRE Manual Del Usuario página 36

EN
36
TROUBLESHOOTING
If an alarm sounds and letters and numbers appear on the display during use,
please follow the instructions in the table below.
Error code Potential cause
The circuit board is
defective.
E1
E2
The device is filled with
water.
Circuit board error, error
in the internal wiring of
the device.
The blender jug does not
fit properly on the device
base.
Water in the base of the
device.
C3
The connection wire in
the device base is loose
and not connected.
Circuit board error.
Temperature controller
with high temperature
protection.
The circuit board is
defective.
EO
EU
The device is filled with
d1
water.
Possible solution
Insert the blender jar and check to
see if the jar or base is damaged. If
the device base is damaged, do the
following:
• Allow the water residue inside
the device to dry naturally to
avoid water damage.
• If the error cannot be rectified,
contact a specialist company for
inspection and repair.
• Overheating the ingredients
can cause them to stick to the
bottom of the container and
can trigger a high temperature
alarm. Clean the food residue
from the blender jug and use
the recommended amount of
ingredients next time.
• Allow the water residue inside
the device to dry naturally to
avoid water damage.
• If the error cannot be rectified,
contact a specialist company for
inspection and repair.
• Allow the water residue inside
the device to dry naturally to
avoid water damage.
• If the error cannot be rectified,
contact a specialist company for
inspection and repair.