Assembly of the Cookie Attachment
You can shape different forms with this attachment after
preparing a cookie dough. This is especially suitable for
spritz biscuits.
• Please also refer to the illustrations under "D" (page 4).
• Please follow points 1 to 4 as described under "Prepa-
ration".
5. First, insert the disco onto the extension of the scroll shaft.
6. Then mount the shaping disc.
7. Rotate the closure clockwise.
Continue reading under "Electrical connection" & "Operation".
Electrical Connection
1. Check whether the mains voltage that you want to use,
corresponds with that of the appliance. You will find the
information about it on the rating plate.
2. Ensure that the switch (3) is set to "OFF". The function
selector switch (4) must be disengaged.
3. Only connect the appliance to a properly installed safety
socket.
Switch Functions
Function Switch ON / R (On / Reverse)
Use the function switch (4) to select the desired operating
mode for the switch (3).
Switch ON / OFF / R (Forward / OFF / Reverse)
The appliance is equipped with a forward and reverse func-
tion. Should the spiral ever become blocked, the reverse
function can be used to release the blockage.
- Forward
• The function selector switch (4) must be disengaged.
• Turn the switch (3) to "ON". The appliance is in the
"forward" mode.
WARNING:
• Always unplug the mains plug from the socket before cleaning.
Wait until the appliance has cooled down.
• Never immerse the motor assembly in water for cleaning. It
could result in an electric shock or fire.
12
FW3803_IM
- Reverse
• Turn the switch (3) to "OFF" and wait until the motor
stops.
• Press the function selector switch (4) so that it is
engaged.
• Press "R" on the switch (3). The appliance will be in
the "reverse" mode as long as you keep the switch
pressed down.
- Switching Off
• Set the switch (3) to "OFF" and pull the mains plug out
of the socket.
WARNING: Risk of Injury!
Always use the supplied tamper. Never insert your fingers
or tools into the filling neck!
CAUTION:
Do not use the appliance for longer than 10 continuous
minutes. Let it cool for 10 minutes before using it again.
1. Put the pieces of meat (meat paste / sausage mass or
dough) on the filling tray and into the filler neck.
2. Stuff, if necessary, the meat respectively the dough with
the tamper.
Ending Operation
1. Pull the mains plug out of the socket.
2. Disassemble all parts of the meat grinder.
3. Clean the parts used as described under "Cleaning".
Disassembly
1. Remove the filling tray.
2. Unscrew the closure in an anticlockwise direction.
3. Remove the accessories from the spiral housing. If
necessary, use a screwdriver to help.
4. Release the spiral housing by pressing the release
button and simultaneously turning the spiral housing
clockwise.
Cleaning
Operation
01.08.23