Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
●Before maintenance and cleaning, gas heater supply must be turned off, the heater should
be cold. Don't attempt to clean the heater while it is in use.
●Your heater should be checked annually by a qualified technician or gas engineer for safe
operation and to detect any faults.
●If any faults are detected in use, stop using the heater immediately and contact your service
provider for advice.
●Periodically clean the exterior and storage area of your heater to remove dust and lint build-
up on the surfaces of the ceramic elements. Do not knock these elements as they may
become very fragile in use.
Do not use abrasive products to clean the heater.
Watch the pilot light while it is in operation. It should burn steadily. If it flickers or is a yellow
flame, the heater should be checked to ensure it is working correctly by a qualified service
provider or gas appliance engineer.
If any parts need replacement, they must be replaced only with correct parts supplied by the
original manufacturer. The use of incorrect or substitute parts may be dangerous and will void
any warranty.
When the heater is not in use, we recommend that it is kept covered, or place in its carton to
minimise the accumulation of dirt that may occur.
Check flexible tubing/hose between regulator and heater regularly and replace if perished,
worn or damaged. It is recommended that the heater be serviced every year by a competent
person in accordance with the latest Gas Safety (installations and use) Regulations. If any
parts need replacing, they should be replaced only with the correct parts as supplied by the
original manufacturer. If not in use after a long time the user should check if heater does work
normally, for example check flexible tubing and regulator conditions are still in the valid time,
the gas connection from cylinder to heater is without any leakage, the heater can be ignited
without light-back and big noise inside heater.
CLEANING
1. Use a wrung out, damp, soapy cloth to clean the exterior and mounting area.
cylinder storage for your heater.
2. Make sure no water gets on burners or pilot/light area.
Completely dry the heater before using it.
3. Do not use abrasive cleaners as they may damage the quality of the paint finish.
STORAGE
1. Disconnect the cylinder and remove it from the appliance.
2. Store cylinders in a well ventilated area away from combustible materials.
Storage should preferably be outdoors. cylinders (carboys)
they should not be stored in a basement or on high-rise floors.
3. The heater should be covered and stored in a dry, dust-free area in its packaging.
original.
Publicidad
