Publicidad
Idiomas disponibles
Idiomas disponibles
It is an employer's responsibility to enforce
the use of appropriate safety protective equip-
ments by the tool operators and by other per-
sons in the immediate working area.
4.
To prevent dust irritation the wearing of a face
mask is recommended.
While operating the machine, always wear
5.
non-slip and protective footwear. Non-skid,
closed-toed safety boots and shoes will reduce the
risk of injury.
Use personal protective equipment. Always
6.
wear eye protection. Protective equipment such
as a dust mask, non-skid safety shoes, hard hat or
hearing protection used for appropriate conditions
will reduce personal injuries.
7.
Inspect the cord before operating the machine.
If the cord is damaged, ask Makita Authorized
Service Centers for repair.
Operation
1.
Switch off the blower and remove the battery
and make sure that all moving parts have
come to a complete stop
•
whenever you leave the blower.
before clearing blockages.
•
•
before checking, cleaning or working on
the blower.
•
if the blower starts to vibrate abnormally.
Operate the blower only in daylight or in good
2.
artificial light.
Do not overreach and keep proper balance and
3.
footing at all times.
4.
Always be sure of your footing on slopes.
5.
Walk, never run.
Keep all cooling air inlets clear of debris.
6.
7.
Never blow debris in the direction of
bystanders.
8.
Operate the blower in a recommended position
and on a firm surface.
9.
Do not operate the blower at high places.
10. Never point the nozzle at anyone in the vicinity
when using the blower.
11.
Never block suction inlet and/or blower outlet.
•
Be careful not to block suction inlet or
blower outlet with dust or dirt when oper-
ating in dusty area.
•
Do not use nozzles other than the nozzles
provided by Makita.
Do not use the blower to inflate balls,
•
rubber boat or the similar.
12. Do not operate the blower near open window,
etc.
13. Operating the blower only at reasonable hours
is recommended - not early in the morning or
late at night when people might be disturbed.
14. Using rakes and brooms to loosen debris
before blowing is recommended.
15. If the blower strikes any foreign objects or
should start making any unusual noise or
vibration, immediately switch off the blower
to stop it. Remove the battery from the blower
and inspect the blower for damage before
restarting and operating the blower. If the
blower is damaged, ask Makita Authorized
Service Centers for repair.
16. Do not insert fingers or other objects into
suction inlet or blower outlet.
17. Prevent unintentional starting. Ensure the
switch is in the off-position before inserting
battery, picking up or carrying the blower.
Carrying the blower with your finger on the
switch or energizing the blower that has the
switch on invites accidents.
18. Never blow dangerous materials, such as
nails, fragments of glass, or blades.
19. Do not operate the blower near flammable
materials.
20. Avoid operating the blower for a long time in
low temperature environment.
21. Do not use the machine when there is a risk of
lightning.
22. When you use the machine on muddy ground,
wet slope, or slippery place, pay attention to
your footing.
23. Avoid working in poor environment where
increased user fatigue is expected.
24. Do not use the machine in bad weather where
visibility is limited. Failure to do so may cause
fall or incorrect operation due to low visibility.
25. Do not submerge the machine into a puddle.
26. When wet leaves or dirt adhere to the suc-
tion mouth (ventilation window) due to rain,
remove them.
Maintenance and storage
1.
Keep all nuts, bolts and screws tight to be sure
the blower is in safe working condition.
2.
If the parts are worn or damaged, replace them
with parts provided by Makita.
3.
Store the blower in a dry place out of the reach
of children.
When you stop the blower for inspection, ser-
4.
vicing, storage, or changing accessory, switch
off the blower and make sure that all moving
parts come to a complete stop, and remove the
battery. Cool down the blower before making
any work on the blower. Maintain the blower
with care and keep it clean.
5.
Always cool down the blower before storing.
6.
Do not expose the blower to rain. Store the
blower indoors.
When you lift the blower, be sure to bend your
7.
knees and be careful not to hurt your back.
9 ENGLISH
Publicidad
