Publicidad
5. MAINTENANCE
●
Temperature limiter cut off electricty if water heater is overheated or thermostat damages.Manual
resetting is needed. Ressetting knob is as follows (see Fig.9).
Manual reset button
!
Non-professionals are not allowed to disassemble temperature limiter to reset . Please
contact prefessionals to maintain. Otherwise our company will not take responsiblity if any
quality accident happens because of this
●
Check the power supply plug and socket frequently to make sure that they have good, reliable
contact and are well grounded without overheating phenomenon.
●
If the heater is not used for a long time, especially in the regions with low atmospheric tempera-
ture(lower than 0℃), the water inside the heater shall be drained away. This will prevent the
damage to the heater due to water freezing in the inner container, (Refer Cautions in this manual
for the method to drain away the water from the inner container).
●
In order to ensure that the water heater operates efficiently for a long time, it is recommended to
clean the inner container and the deposits on the electrical heating components periodically.
●
It is recommended to examine the magnesium anode protection materials every six months or
so. If all the material has been consumed, please replace with the new material.
!
Do cut off power supply before maintenance, to avoid danger like electric shock.
WARNING
WARNING
9
(Fig.9)
Publicidad
