Initial Operation; Switching On And Off - Urrea NL2 Manual De Usuario Y Garantía

ASSEMBLY
Inserting/Replacing the Battery
The battery compartment holds two "AAA"
batteries.
1. Push the latch to open the battery cover.
2. Insert two new"AAA" alkaline batteries,
following the polarity (+/-) as indicated on the
pole plate.
3. Securely close the cover.
NOTE:
• Always turn off the tool before installing or
replacing the batteries.
• Remove the batteries from the tool when not
using it for extended periods.
• The AAA batteries should match each other
in brand and type.
• Do not mix old and new batteries.
• Remove depleted batteries immediately, and
dispose of them according to the laws and
regulations governing your community.

INITIAL OPERATION

Protect the measuring tool against moisture
and direct sun light.
• Do not subject the measuring tool to extreme
temperatures or variations in temperature. As
an example, do not leave it in vehicles for lon-
ger periods. In case of large variations in tem-
perature, allow the measuring tool to adjust
to the ambient temperature before putting it
into operation.
• Avoid heavy impact to or falling down of
the measuring tool. Damage to the measuring
tool can impair its accuracy. After heavy impact
or falling down, check the angle accuracy be-
tween the 0° and 90° laser line with the angle
of a precision square.

SWITCHING ON AND OFF

Push the power switch up to turn the self-
levelling cross-line laser level on, and slide the
power switch down to turn the tool off
LEVELING FUNCTION
SELF-LEVELLING mode
In this mode, the tool will level itself if it is
within ±3° of horizontal.
1. Place the self-levelling cross-line laser level
on a flat, smooth surface that is within ±3° of
horizontal.
2. Turn the tool on by sliding the power switch
to the up position. The self-levelling cross-line
6
laser level will automatically level within 5 sec-
onds. The LED indicator will shine green.
3. When the self-levelling cross-laser out of
levelling the LED will turn to red and the laser
line will blink.
4. To turn off the laser lines, slide the switch to
down position.
WARNING: When turning the laser on, al-
ways be aware of protecting your eyes and the
eyes of those around you. Never point the laser
light at anyone's face, including your own.
APPLICATIONS
Your self-levelling cross-line laser level can be
hand-held for point marking and simple align-
ment by sight . It is ideal for the following ap-
plications:
• Hanging pictures, photos, or artwork on
walls.
• Wallpapering and stencil work.
• Framing doors and windows.
• Installing electrical wiring and pipes.
• Mounting wall fixtures, electrical outlets,
switches and lighting.
• Installing a drop ceiling.
• Painting.
• Installing closets.
• Laying tile and flooring.
OPERATION
Working with the Tripod
(see figure A)
A tripod offers a stable,
height-adjustable mea-
suring support. Place the
measuring tool via the tri-
pod mount on to the 1/4"
male thread of the tripod
and screw the locking
screw of the tripod tight.
Holding Laterally against
a Wall or Object (see fig-
ure B)
For quick checking
heights, the measuring
tool can be held by the
contact surfaces later-
ally against a vertical wall,
cabinets, etc. Take care to
hold the measuring tool
straightly and calmly.
Fig. A
of
Fig. B