Publicidad
Installation
Assembly steps
Provide necessary tool.
Unplug the appliance.
Remove the left and right hinge cover,disconnect
3.
the wiring harness connection terminal between
the door body and the box body,remove the three
screws from the upper hinge and remove the door
body.
4.
The hinge side shaft sleeve passes through the
wiring harness terminal and is taken out from the
door body,remove the decorative cover on the
door opening side and pull out the hidden wiring
harness from the door body.
5. Install the removed shaft sleeve through the wiring
harness terminal to the other side of the door body,
the wiring harness terminal on the other side is hid-
den inside the decorative cover, extend the wiring
harness into the body, and buckle the decorative
cover.
6.
stop at the bottom of the door body and install
them on the other side of the door body.
7. Remove the lower hinge screw at the bottom of
of the box.
8. Install the door body onto the lower hinge of the
body,the door harness is connected to the box
harness terminal and placed inside the box, with
screws securing the upper hinge.
9. Install the hinge cover and decorative cover, and
complete the left and right door replacement.
18
EN
1
2
1
3
4
4.1
5
6
7
8
9
Publicidad
