Cameo LEYA 2000 RGB Manual De Usuario página 8

3. The exterior surface of the device can become very hot during regular operation.
Ensure that accidental touching of the housing is not possible. Always allow the
device to cool sufficiently before removal, maintenance work and charging etc.
ATTENTION:
1. Do not install and operate the device in the vicinity of radiators, heat accumulators,
ovens, or other heat sources. Ensure that the device is always installed in such a
way that it is sufficiently cooled and cannot overheat.
2. Do not place ignition sources such as lighted candles near the device.
3. Vents must not be covered and fans must not be blocked.
4. Use the original packaging or packaging provided by the manufacturer for trans-
port.
5. Avoid shock or impact to the device.
6. Observe the IP rating as well as the ambient conditions such as temperature and
humidity according to the specification.
7. Devices can always be further improved. In the event of any discrepancies between
the operating instructions and the device labelling with regard to operating condi-
tions, performance or other device characteristics, the information on the device
always takes precedence.
8. The device is not suitable for tropical climates and for operation at elevations high-
er than 2000 m above sea level.
9. Unless explicitly stated, the device is not suitable for operation in marine condi-
tions.
CAUTION! IMPORTANT INFORMATION REGARDING LIGHTING PRODUCTS!
Stroboscopic effects may cause epileptic seizures in susceptible individuals!
8