Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions
Instructions for filling the grease gun (three options)
Insert a cartridge (Fig. 2)
a. Remove the cartridge cylinder.
b. Pull back the piston completely.
c. Remove the old cartridge. Insert a new cartridge into the cylinder
d. Mount the cartridge cylinder. Press the driving plate and the piston rod back down.
Pump filling (Fig. 3)
a. Pull back the piston completely.
b. Loosen the round nozzle. Connect the filling adapter with the filling pump.
c. Now operate the filling pump.
d. Disconnect after filling the grease gun from the filling pump.
e. Press the driving plate and the piston rod back down.
Hand filling (Fig. 4)
a. Remove the cartridge cylinder.
b. Pull back the plunger completely. Fill the cartridge by hand, now with a lubricant of your choice.
c. Mount the cartridge cylinder on the grease gun. Press the driving plate and the piston back down.
The precision trigger should be kept during the entire filling.
Oil the grease gun every day or before each use.
Fig.2
Maintenance
Add a little oil a day through the air hose coupling in the tool.
Troubleshooting
If the grease gun does not work properly, there is probably a problem with air in the grease gun. To fix
the error, follow this instruction:
1. Remove the pipe.
2. Loosen the cartridge cylinder about one to two rotations.
3. Pull out the piston rod a few times and push them back. The excess air will pump out.
4. Press the trigger button and test whether of grease flow.
5. Repeat the above steps if necessary.
6. Tighten the cartridge cylinder again.
7. Reinstall the pipe.
8. The air is removed and the grease gun works perfectly again.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
Fig.3
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
Fig.4
Publicidad
