Kicker 19434975 Instrucciones página 4

Install the supplied threaded clips. Fig 4
Install the amplifier mounting bracket through the right of center hole and secure with the tailgate handle
bolts and the two supplied bolts. Fig 5
Re-attach the wire retainers to the amplifier bracket
Note: Make sure no wires are pinched between the amplifier bracket and tailgate.
front of vehicle
Install the amplifier onto the amplifier bracket with
the supplied screws (short screws x 4). Fig 6
Connect the amplifier harness to the amplifier and
the four-pin connector to the tilt switch attached to
the amplifier bracket. Fig. 7 Route the harness
along the factory harness toward the passenger
side.
Secure the amplifier harness with one of the two
supplied retainers. Fig. 7
Note: The tilt switch is designed to turn the
speaker system off when the inner
tailgate is not in the fully down
position. Failure to make this
connection or attempting to bypass
this switch will result in a constant drain on the vehicle battery. Likewise, any
cutting, splicing or any other modifications made to the amplifier harness will
immediately void the warranty.
Disconnect the connector pictured and install the light kit T-harness (if equipped). Fig 7
Fig 4
Fig 5
Fig 6
4