Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE GRASS CATCHER (FOR REAR BAGGING OPERATION) (3)
NOTE
When using the grass catcher (D), do not install
the mulching plug.
•
Remove battery.
•
Lift the rear discharge door (N).
•
Lift the grass catcher (D) by its handle and place under the
rear discharge door (N) so that the hooks on the grass catcher
are seated onto the slots on the mower housing.
•
Release the rear discharge door (N).
•
Reinstall battery when you are ready to mow.
TO INSTALL BATTERY (4)
WARNING
Always remove battery from your tool when you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery will prevent accidental starting that could cause
serious personal injury.
•
Raise the battery cover (J).
•
Place the battery in the mower.
•
Align raised ribs on battery with grooves in the mower's
battery port.
•
Push down into battery compartment until the battery
clicks into place.
•
Lower the battery cover.
WARNING
Make sure the latch on top of the battery
release button snaps in place and the
battery is fully seated and secure in the
mower's battery port before beginning
operation. Failure to securely seat the
battery could cause the battery to fall out,
resulting in serious personal injury.
To remove the battery:
•
Press the battery release button (O) on the mower. This
will cause the battery to raise out of the tool slightly.
•
Raise the battery cover.
•
Remove battery from the mower.
N
D
J
O
61
EN
Publicidad
