Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: failure to properly install and tighten the U front fork could allow the wheel to fall off
during use and cause serious injury.
•
Insert inner axle shaft. Shaft will slide through the outer axle shaft from one side to the other and extend past fork. It
fork lock clamp and washers and then attach inner axle rod nut.
16
WARNING: You cannot tighten the quick release lever bymerely twisting it. You can only ensure it
is locked by properly tightening the finger nut and then flipping the quick release lever from open
to closed (Fig 16 & 17).
•
Tighten inner axle shaft clamp and then lock down to ensure tight fit.(Fig 18 & 19).
18
STEP 7. ATTACHING THE TRAILER TO THE BIKE
•
Loosen the left side of the rear axles to allow the hitch to attach to the bike frame (Fig 20).
•
Position the hitch over the left rear axle of the bike (Fig 21).
•
Tighten the axle nut securely, testing to see if the hitch can be pulled loose (Fig 21) and then repeat safety test.
20
•
Loop safety strap around the frame and secure to the D ring on the hitch arm (Fig 22).
22
35
BIKE TRAILER BIKID
17
19
21
EN
Publicidad
