Descargar Imprimir esta página

Craftsman 917.374822 Manual De Instrucciones página 17

Publicidad

Idiomas disponibles

Idiomas disponibles

Immediately
prepare
your lawn mower for storage
at the end of the season
or if the unit
will not be used for 30 days or more.
LAWN
MOWER
When
lawn mower
is to be stored
for a
period of time, clean
it thoroughly,
remove
all dirt, grease,
leaves,
etc. Store
in a
clean, dry area.
1.
Clean
entire lawn mower
(See
"CLEANING"
in the Maintenance
sec-
tion of this manual).
2.
Lubricate
as shown
in the Maintenance
section
of this manual.
3.
Be sure that all nuts, bolts, screws,
and
pins are securely
fastened.
Inspect
moving
parts for damage,
breakage
and wear.
Replace
if necessary.
4.
Touch up all rusted or chipped
paint
surfaces;
sand lightly before
painting.
SQUEEZE
Handle
bracket
Handle pin
HANDLE
You can fold your mower
handle for storage.
NOTE: The upper
handle
has an "anti-fold"
bracket
located
on the right side of the
handle.
This bracket
prevents
the upper
handle from folding
forward,
which
helps
protect
control
cable(s)
from damage.
1.
Loosen
the two (2) handle
knobs on
sides of the upper
handle
and allow
handle
to fold down to the rear.
2.
Squeeze
the bottom
ends of lower
handle
toward
each other until pins
in handle
clear the brackets
and pivot
entire
handle
assembly
forward
and
allow it to rest on mower.
• When
setting
up your handle
from the
storage
position,
you must manually
lock lower handle
into mowing
position.
IMPORTANT:
When
folding
the handle
for
storage
or transportation,
be sure to fold
the handle
as shown
or you may damage
the control
cables.
Operator presence
control bar
Upl
Lower
Mowing
position
ENGINE
FUEL SYSTEM
IMPORTANT:
It is important
to prevent
gum deposits
from forming
in essential
fuel system
parts such as carburetor,
fuel
filter, fuel hose, or tank during
storage.
Alcohol
blended
fuels (called
gasohol
or
using ethanol
or methanol)
can attract
moisture
which leads to separation
and
formation
of acids during
storage.
Acidic
gas can damage
the fuel system
of an
engine
while
in storage.
• Empty
the fuel tank by starting
the en-
gine and letting
it run until the fuel lines
and carburetor
are empty.
• Never use engine
or carburetor
cleaner
products
in the fuel tank or permanent
damage
may occur.
• Use fresh fuel next season.
NOTE:
Fuel stabilizer
is an acceptable
alternative
in minimizing
the formation
of
fuel gum deposits
during
storage.
Add
stabilizer
to gasoline
in fuel tank or stor-
age container.
Always
follow the mix ratio
found on stabilizer
container.
Run engine
at least 10 minutes
after adding
stabilizer
to allow the stabilizer
to reach the car-
buretor.
Do not empty
the gas tank and
carburetor
if using fuel stabilizer.
ENGINE OIL
Drain oil (with engine warm) and replace
with clean engine oil. (See "ENGINE" in
the Maintenance
section of this manual).
17

Publicidad

loading