Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
TO AVOID RISK OF
ELECTRICAL
SHOCK!
Repairs or replacement
of parts
may be carried out by authorized
technicians
only.
Problem
Dryerdoesnotstart.
"Start/St0p"indicatorHghtdoesnot
illuminate.
Programhas beeninterrupted.
A warningsignalis emittedand the
displayshows"E:O1".
Degreeof dryinghasnot beenreached
or the dryingtime istoo long.
Displaymay indicate"g:03".
Drumfightdoesnot function.
Before calling the customer service,
check whether you can rectify the fault
yourself by means of the following
table.
If a fault cannot be rectified or a repair
is required:
Possiblecause
Mainplug not inse_ted at all or not insertedcorrectly.
A fuse of powersupplyhastripped.
"Start!Stop"buttonnot pressed.
Noprogramselected.
Doornot closed.
Ambienttemperaturebelow41 °F/5 °C.
Lintfilter dirty.
Exhaust air duct is blockedor too long.
Faultin programsequence or malfunction.
The room/cabinet i s not adequately ventilated.
Moisturesensordirty.
Exhaust a ir duct is blockedor too long.
Lintfilter dirty.
Laundry was too wet.
Unsuitable programselected.
Maximum dryingtime was exceeded.
Motorlimit temperaturewas exceeded.
Noprogramselected.
Lightbulb defective,light bulb burnedout.
Nopowersupply.
Lightbulb is loose.
1. Set program selector to "Off".
2. Turn off the circuit breaker.
3. Pull the main plug out of the
socket.
4. Call customer service
(see page 21 ).
"StaWStop" indicatorlightdoesnot
Faultin programsequence or malfunction.
ifluminate."Wnnk]eblock" indicator
lights.
Thedisplayshows"000".
Lintfilter LEDis blinkingafter tint filter
Blinkingof lintfilter LEDis not an indicationof a
Noaction required. Lightwill stop bflnking.
hasbeencleaned
problem. It is usedonlyas a reminder,
Remedialaction
Insertmainplug correctly.
Replace/switch o n fuse.
Press"Start/Stop"button.
Selectprogram,
Closedoor.
Increaseroomtemperature.
Cleanfilter asdescribedon page18.
Switchoff/switchon again.
Cleanexhaustair duct. Reduce exhaustair duct to
maximumlength as described on page8.
Switchoff/switchon again.
Switchoff dryer,leave to cooldownfor 30 min,
switchon again.
Restartprogram.
Providean adequatesupplyof fresh air.
Switchoff/switchon again.
Cleanmoisturesensoras described on page18.
Switchoff/switchon again.
Cleanexhaustair extraction,Reduce exhaustair duct
to maximum length as described on page8.
Switchoff/switchon again.
Cleanfilter asdescribedon page18.
Switchoff/switchon again,
Spin laundryat higherspeedin the washing
machine,Switchoff/switchon again.
Selectprogramwith aid of the programselection
table(seepage 15).Switchoff/swkchon again.
Cleanlintfilter (seepage18).
Checkexhaustair extraction.
Spin laundryat a higherspeedin your washer.
Switchoff dryer,leave to coo]downfor 30 min.
Switchon again,Start program.
Selectprogram.
Changelight bulb,seepage19.
Guarantee powersupply.
Tightenlightbulb. Remove and reinstallthe coveras
directedon page24.
Switchoff dryer,leave to cooldownfor 30 min,
switchon again.
Restartprogram.
2O
Publicidad
