Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT SAFETY INSTRUCTIONS
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK OR INJURY
TO PERSONS. SAVE THESE INSTRUCTIONS.
WARNING – When using electrical appliances,
basic precautions should always be followed,
including the following:
1. Read all instructions before using the appliance.
2. To reduce the risk of injury, close supervision is
necessary when an appliance is used near children.
3. Do not put fingers or hands into a waste disposer.
4. Turn the power switch to the off position or unplug the
appliance before attempting to clear a jam or remove
an object from the disposer.
5. When attempting to loosen a jam in a waste disposer,
use a long wooden object such as a wooden spoon or
the wooden handle of a broom or mop.
6. When attempting to remove objects from a waste
disposer use long-handled tongs or pliers. If the
disposer is magnetically actuated, non-magnetic tools
should be used.
7. To reduce the risk of injury by materials that may be
expelled by a waste disposer, do not put the following
into a disposer: clam or oyster shells; caustic drain
cleaners or similar products; glass, china or plastic;
large whole bones; metal, such as bottle caps, tin
cans, aluminum foil or utensils; hot grease or other hot
liquids; whole corn-husks.
8. When not operating a disposer, leave the stopper in
1. REMOVAL OF OLD UNIT
TYPICAL INSTRUCTIONS, YOUR MODEL MAY VARY.
Before starting this step, turn off electrical
power at the circuit breaker or fuse box. Unplug
disposer.
If your old mount is the same type as the mount on your
new disposer, just reverse the assembly instructions found
in section 3. If your new mount system is different, follow
these instructions:
A. Have a container available to catch any excess water
/ waste from current disposer.
B. Use a pipe wrench to disconnect drain line where it
attaches to disposer discharge elbow (see 1A).
C. Remove disposer from sink flange by turning mount
ring to the left clockwise (see 1B). If you are unable to
turn the mount ring, tap on one of the extensions from
the ring with a hammer. Some mounting systems have
tubular extensions. Inserting a screwdriver into one
tube will provide additional leverage for turning the
mount ring (see 1B). Some disposers may require the
removal or loosening of nuts from the mount screws
(see 1C). Some disposers may require the removal of
a clamp.
1A
place to reduce the risk of objects falling into the
disposer.
9. DO NOT operate disposer unless splash guard is in
place.
10. For proper grounding instructions see the ELECTRICAL
CONNECTIONS portion of this manual.
11. The appliance must be installed so that reset buttons
and reversing switches are readily accessible.
12. This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should be
supervised to ensure that they do not play with the
appliance.
13. If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
14. At least 6L/min of water flow is required to operate the
appliance.
The receptacle to which this appliance is
connected must be controlled by a switch.
Caution: Be sure to support the disposer while
performing this step or it may fall when the mounting
ring is disconnected from the mounting assembly.
D. To remove remaining mount system from the sink,
loosen mount screws, push mount ring up. Under it is
the snap ring. Use screwdriver to pop off ring (see
1D). Remove mount ring, protector ring and gasket
from sink flange. Some mounts will require the
unscrewing of a large ring holding the sink flange in
place. Pull sink flange up through sink and clean off
old putty from sink.
E. Ensure that sink is clean and thoroughly dry.
IMPORTANT: This is a good time to clean
out the trap and drain lines by running a
drain auger or plumber's snake before
installing your new disposer.
1B
3
1C
1D
Publicidad
