Teka TRS 520 Manual De Usuario página 6

3. DISHWASHER CONNECTION PREPARATION
If you are utilizing a dishwasher, complete the following procedure.
Using a blunt instrument (steel punch or wooden dowel), knock out entire plug. Do not use a
screwdriver or sharp instrument. (When knockout plug falls into disposer, you may remove it
or grind it up when the disposer is used. This will not damage the disposer in any way, but it
may take some time to grind).
4. LOCKING MOUNTING ASSEMBLY DETAIL
Attach disposer onto the Upper Mount Ring by aligning the three mount tabs on the Lower Mount
Ring with the slide-up Ramps on the Upper Mount Ring and rotating counter clockwise. See Below.
B
The lower mounting ring (which is part
of the disposer) has 3 tabs that grab the
mounting ring ramp.
(A) points to the Upper Mount Ring.
(B) is the tab that slides up onto the
"Ramp".
(C) is the "Ear" that is used to help
rotate the Lower Mount Ring. Use a
screwdriver for leverage if needed.
5. DISCHARGE ELBOW & DISHWASHER CONNECTIONS
A. Connect the waste elbow to the disposer by sliding the flange
against the rubber gasket on the elbow and tightening the
screws into the disposer (see 5A). Then connect bottom of
the elbow by tightening the slip nut (see 5B).
straight pipe, it must have a lip similar to the one on the
elbow. Remove the gasket from the elbow and install it on the
straight pipe with the flat end of the gasket facing toward the
disposer discharge opening. IF YOU ARE NOT
CONNECTING TO A DISHWASHER make sure all plumbing
connections are tight and in accordance with all plumbing
codes and ordinances. Run water and check for leaks. Go on
to Step 6.
B. Connect dishwasher hose (see 5C) using hose clamp. Make
sure all plumbing connections are tight and in accordance
with all plumbing codes and ordinances. Run water and check
for leaks.
A
C
Lift and turn the Lower
Mount Ring counter clock-
wise until all three mount
tabs lock over the Ridges (F)
on the slide-up Ramps (D) of
the Upper Mount Ring.
If using a
D
5A
DISPOSER
6
WOOD OR
METAL DOWEL
F
E
As the Lower Mount Ring is turned counter
clockwise each tab slides up onto the Upper
Mount Ring Ramp (E) and locks in position
over the Ridges (F).
Use a screwdriver or hammer for leverage if
needed.
If a disposer needs to be removed, tapping on
the Ear clockwise with a hammer will easily
loosen the Lower Mount Ring.
RUBBER
GASKET
5B
AIR GAP
*
5C
RUBBER
HOSE
DISHWASHER
HOSE
DRAIN
*Air gap may not be required for all
installations. Check local plumbing
codes.
KNOCK
OUT PLUG