Palram Aquila 2050 Manual De Instrucciones página 4

C!D Door Cover
Attention!
Please read
these instructions carefully before you start to assemble this product.
Please
carry out the
steps in
the order
set
out
in
these instructions.
Keep these
instructions
in a
safe place for
future
reference.
Safety Advice
Sort the parts and check against the content
list.
For
safety purposes we strongly recommend the product
be
assembled by two people.
We strongly recommend the
use
of work gloves during assembly.
Do
not attempt to assemble the Door Cover
in
windy or wet conditions.
Always wear shoes and safety goggles.
Dispose of
all
plastic
bags safely
-
keep them out of
reach
of small children.
Keep children away from the assembly area.
Do
not attempt to assemble the Door Cover if you
are
tired,
have
taken drugs, medication
or alcohol, or if you
are prone to dizzy spells.
When using
a
stepladder or power tools, make sure
that you follow the manufacturers
safety advice.
Be sure
to check that there are no hidden pipes or cables
in
the wall before drilling.
Please
consult your
local
authorities if any permits
are
required to install
a
Door
Cover.
Before assembly,
consider the door's opening (inside or outside).
Please
apply silicone sealant to the
rear
edge
in
order to prevent water
seepage.
Tighten
all screws
when completing assembly.
Keep
roof and gutter clear of snow, dirt
& leaves.
Heavy snow load on
roof
can
damage the product making it unsafe to stand below or
nearby.
Cleaning
instructions
Clean
the product once assembly
is
complete.
When
your Door
Cover needs cleaning, use
a
mild detergent solution and
rinse
with
cold
clean water.
Do
not
use
acetone, abrasive cleaners or other
special
detergent to
clean
the
panel.
Additional information
The wall anchoring kit supplied
with
this product
is
suitable only for concrete walls.
Other wall types need
an
accordant wall fixation
kit.
Please apply silicone sealant if needed
You are
solely responsible for determining whether the handling, storage, assembly,
installation or
use
of this product
is
safe
and appropriate
in any
location or for any given
application.
The
manufacturer
is
not responsible for
any damages
or injury to you, any other
person or any property resulting from the improper handling, storage, installation, assembly
or
use
of this product, or the failure to follow the manufacturer's written instructions
regarding the handling,
storage,
installation, assembly and
use
of this product.
This
product
is
intended for normal residential
use
only.
Do
not
use
this product for any application that
is
not recommended
in
these instructions or building codes
in
effect
in
location where this
product will
be used.
Always take care and
use
appropriate
safety
equipment (including
eye
protection) when assembling or installing this product.
Please
note:
it
is
possible to extend the canopy, however once fully assembled
it
is
impossible to add the extension.