ANSMANN BC 6-12B/1 A Manual De Operación página 16

3. The charger automatically starts charging the battery. The green LED flashes.
4. When charging is complete, the LED status indicator lights up solid green. The
charger automatically switches to maintenance charging.
5. If you would like to disconnect the charger again, begin by disconnecting it from
the mains before you disconnect the terminals from the battery.
circle-c NOTE:
If the charger shows a fully charged battery after a few minutes, this indicates that
the battery was already full before charging or that the battery is old or damaged. In
this case, the battery must be replaced.
7.1. SAFETY FEATURES
This battery charger comes with the following safety features:
• Short-circuit protection
• Protection against reverse polarity
8. MAINTENANCE AND CARE
This charger requires only minimal maintenance. As with any device or tool, certain
measures extend the life of the battery charger.
1. Store the charger in a clean, dry place.
2. Wind up the cable when it is not being used.
3. Clean the housing and the cable with a slightly damp cloth.
4. Clean the terminals with a solution of water and baking powder to protect them
from corrosion.
5. Examine the cables regularly for cracks or other damages and have them replaced
if applicable.
circle-c NOTE
Always make sure that the charger is disconnected from the mains before you carry
out maintenance and cleaning work.
triangle WARNING:
All other maintenance work should only be carried out by qualified personnel.
9. TROUBLESHOOTING
Status LED
flashes Battery is not
red charging
Battery is not
charging
Flashes
fast green
Battery is not
recognised
16
Situation
Terminals connected
to the battery with the
wrong polarity
Short circuit between
charger terminals
No battery connected
Battery not connected
correctly
DE | EN | FR | ES | PT | SE | IT | NL | DK | FI | NO | PL
Possible problem Solution
Connect terminal
correctly
Make sure that the
terminals do not make
contact
Connect a battery
Check charger connec-
tion to battery