Publicidad
Idiomas disponibles
Idiomas disponibles
ADDITIONAL SAFETY
INSTRUCTIONS FOR
CUTTING-OFF OPERATIONS
Additional Safety Warnings Specific for
Abrasive Cutting-Off Operations:
a) Do not "jam"the cut-off wheel
or apply excessive pressure. Do
not attempt to make an excessive
depth of cut. Overstressing the wheel
increases the loading and susceptibility to
twisting or binding of the wheel in the cut
and the possibility of kickback or wheel
breakage.
b) Do not position your body in line
with and behind the rotating
wheel. When the wheel, at the point of
operation, is moving away from your
body, the possible kickback may propel
the spinning wheel and the power tool
directly at you.
c) When wheel is binding or when
interrupting a cut for any reason,
switch off the power tool and hold
the power tool motionless until the
wheel comes to a complete stop.
Never attempt to remove the cut-off
10
wheel from the cut while the wheel
is in motion otherwise kickback may
occur. Investigate and take corrective
action to eliminate the cause of wheel
binding.
d) Do not restart the cutting operation
in the workpiece. Let the wheel
reach full speed and carefully
reenter the cut. The wheel may bind,
walk up or kickback if the power tool is
restarted in the workpiece.
e) Support panels or any oversized
workpiece to minimize the risk of
wheel pinching and kickback. Large
workpieces tend to sag under their own
weight. Supports must be placed under
the workpiece near the line of cut and
near the edge of the workpiece on both
sides of the wheel.
f) Use extra caution when making a
"pocket cut" into existing walls
or other blind areas. The protruding
wheel may cut gas or water pipes,
electrical wiring or objects that can cause
kickback.
Cordless Mini Cutter
SAFETY WARNINGS FOR
BATTERY PACK
a) Do not dismantle, open or shred
battery pack.
b) Do not expose battery pack to
heat or fire. Avoid storage in direct
sunlight.
c) Do not short-circuit a battery
pack. Do not store battery packs
haphazardly in a box or drawer
where they may
short-circuit each other or be
short-circuited by other metal
objects. When battery pack is not in use,
keep it away from other metal objects,
like paper clips, coins, keys, nails, screws
or other small metal objects, that can
make a connection from one terminal to
another. Shorting the battery terminals
together may cause burns or fire.
d) Do not remove battery pack from its
original packaging until required for
use.
e) Do not subject battery pack to
mechanical shock.
f) In the event of battery leaking,
do not allow the liquid to come in
contact with the skin or eyes. If
contact has been made, wash the
affected area with copious amounts
of water and seek medical advice.
g) Observe the plus (+) and minus
(–) marks on the battery back and
equipment and ensure correct use.
h) Do not use any battery pack which
is not designed for use with the
equipment.
i) Keep battery pack out of the reach
of children.
j) Seek medical advice immediately if a
cell or battery has been swallowed.
k) Always purchase the battery
pack recommended by the device
manufacturer for the equipment.
l) Keep battery pack clean and dry.
m) Wipe the battery pack terminals
with a clean dry cloth if they
become dirty.
n) Battery pack need to be charged
before use. Always use the
correct charger and refer to the
manufacturer's instructions or
equipment manual for proper
charging instructions.
EN
Publicidad
