MAINTENANCE
Remove the battery before carrying
out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through
the ventilation slots. This is normal and
will not damage your power tool. Store the
accessories in a dry place.
14
14
Cordless Mini Cutter
TROUBLESHOOTING
Although your new mini cutter is really very
simple to operate, if you do experience
problems, please check the following:
1. If your grinder wheel wobbles or vibrates,
check that outer flange is tight; check that
the wheel is correctly located on the flange
plate.
2. If there is any evidence that the wheel is
damaged do not use as the damaged wheel
may disintegrate, remove it and replace
with a new wheel. Dispose of old wheels
sensibly.
3. If working on aluminum or a similar soft
alloy, the wheel will soon become clogged
and will not grind effectively.
4. When overloaded, the motor comes to a
stop.
Relieve the load on the machine
immediately and allow cooling for approx.
30 seconds at the highest no-load speed.
5. When using as intended for the power tool
cannot be subject to overload. When the
load is too high or the allowable battery
temperature of 75°C (167°F)is exceeded,
the electronic control switches off the
power tool un
til the temperature is in the
optimum temperature range again.
6. If machine is blocked, please turn it off and turn
it on again after 1~2 seconds.
EN