Publicidad
Idiomas disponibles
Idiomas disponibles
ditches, etcetera) in case you have to move
suddenly. Take great care when you work on
sloping ground.
•
Keep a good balance and a firm foothold at all
times. Do not overreach.
•
Listen out for warning signals or shouts
when you wear hearing protection. Always
remove your hearing protection as soon as
the product stops.
•
Do not operate the product near open
windows.
•
Show consideration to persons in your
surroundings by avoiding using the product
at unsuitable times, such as late in the
evening or early in the morning. Follow local
regulations and ordinances.
•
Use the product with the lowest possible
airflow. It is seldom necessary to use full
airflow, and many work procedures can be
done at half airflow. A lower airflow means
less noise and less dust, and it is also easier
to keep control over the rubbish collected
together/moved.
•
In dusty conditions slightly dampen the
surface when using the product.
•
Use a rake or a brush to release rubbish stuck
to the ground.
•
Hold the opening of the blower as close to the
ground as possible.
•
Observe your surroundings. Direct the product
away from persons, animals, play areas, cars
etc..
•
Minimize the blowing time by lightly wetting
dusty areas or using spray equipment.
•
Be aware of the wind direction. Work with the
wind to make your work easier.
•
Stop the product and remove the battery if the
product starts to vibrate abnormally.
•
Using the blower to move large piles is time
consuming and creates unnecessary noise.
•
Clean up afterwards. Make sure that you have
not blown rubbish into someone's garden.
•
Do not run with the product.
•
The powerful currents of air can move objects
at such a speed that they can bounce back
and cause serious eye injuries.
(Fig. 15)
•
Do not direct the airflow towards people or
animals.
•
Stop the motor before you assemble or
dismantle accessories or other parts.
1516 - 008 - 29.11.2023
•
Keep all parts of your body away from hot
surfaces.
•
Never put the product down when it is
activated unless you have it in clear sight.
•
Stop the machine, and remove the battery.
Make sure that all moving parts have come to
a complete stop:
•
whenever you leave the machine
•
before clearing blockages or unclogging
chute
•
before checking, cleaning or working on
the machine
•
Immediately shut off the power source and
allow the machine to stop if the cutting
mechanism hits any foreign objects or if the
machine should start making any unusual
noise or vibration. Disconnect the battery from
the machine and take the following steps
before restarting and operating the machine:
•
examine for damage
•
replace or repair any damaged parts
•
check for and tighten any loose parts
•
Shut off the power source and disconnect
the machine from battery before cleaning
unwanted material if the machine becomes
clogged.
•
Do not transport this machine while the power
source is running.
•
Do not tilt the machine while the power source
is running.
•
The blower must not be used while on a
ladder or scaffolding.
(Fig. 16)
•
Do not use the product unless you are able to
call for help in case of an accident.
•
Watch out for thrown objects. Stones, rubbish,
etc., can be thrown up into the eyes causing
blindness or serious injury.
•
Use a residual-current device (RCI) for
increased security when you charge the
product. A residual-current device is fitted to
protect operators in case an electrical fault
should occur.
•
This product is renowned for its low vibration
load. Overexposure to vibration can lead
to circulatory damage or nerve damage in
people who have impaired circulation. Contact
your doctor if you experience symptoms of
overexposure to vibration. Such symptoms
include numbness, loss of feeling, tingling,
11
Publicidad
