Storage Instructions; Troubleshooting; Before Returning For Repair - DSR INDUSTRIAL Serie Manual Del Usuario

15.3 Have any cracked or frayed cables replaced by an authorized service
person.
15.4 Servicing does not require opening the unit, as there are no user-service-
able parts.
16.

STORAGE INSTRUCTIONS

16.1 Store charger unplugged, in an upright position. Cord will still conduct
electricity until it is unplugged from the outlet.
16.2 Store inside, in a dry, cool place (unless you're using an on-board Marine
Charger).
16.3 Do not store clips on handle, clipped together, on or around metal, or
clipped to cables.
17.

TROUBLESHOOTING

LED GUIDE/PROBLEM
The charger is plugged in
but the POWER ON (red)
LED is not lit.
The battery is connected
and the POWER ON
(red) LED is on, but the
CHARGING (yellow) LED
is not lit and charger is not
charging.
18.

BEFORE RETURNING FOR REPAIR

Please do not return for repair before speaking to a customer service
representative (1-800-621-5485).
18.1 When a charging problem arises, make certain that the battery is capable
of accepting a normal charge. Use a good battery to double check all con-
nections, AC outlet for a full 120-volts, charger clamps for correct polarity,
and the quality of the connections from the cables to the output connector
and from the output connector to the battery system. The output connec-
tors must be clean.
POSSIBLE CAUSE
No power at the AC
receptacle.
Poor electrical connection.
The battery charger is not
functioning properly.
Battery connectors are not
making a good connec-
tion.
The battery is bad.
The battery charger is not
functioning properly.
9
• •
SOLUTION
Check for open fuse or
circuit breaker supplying
AC outlet.
Check power cord and
extension cord for loose
fitting plug.
Call customer service
621-5485)
(1-800-
Check for poor connection
at battery. Make sure con-
necting points are clean.
Have the battery checked
by a qualified service
person.
Call customer service
(1-800-621-5485).
.